Clutch Assembly, Complete, from 2007 mid-mile. Spec'd out as good, with very even wear excepting one disk (marked for you) is at minimum spec, should be replaced. Disks: High measurement 3.80 MM, low measurement 3.72mm with one as noted needed to be replaced (22201-MCA-000, $19). Plates: High measurement 2.02mm, low 2.00 mm. Both aspects are good, excepting the disk needed. Lifter Spring: 2.65mm, Clutch Spring: 4.68mm. These specs are usable, but I would replace both the springs when you are ordering the disk and staker-nuts (parts: Clutch spring 2441-MCA-000, $18, Clutch lifter spring 22355-MCA-000 $16). With those renewed (the springs are usually always renewed when over-hauling regardless, unless they are very good) you will have an excellent clutch that will last a reasonable driver for the life of the bike. ALL aspects are there, disks, plates, rings, clips, washers, and inluding the used nuts, which you should buy new ones for, as they are 'staking-nuts'.
MADE IN THE USA
MADE IN THE USA
THERE ARE NO TARRIFS ON THIS ITEM.
GL1000 GL1100 GL1200 Vintage parts Used and New
